Ceph Jewel to Luminous

Note: the current Ceph Luminous 12.1.x is the release candidate, for production ready Ceph Cluster packages please wait for version 12.2.x

Introduction

This HOWTO explains the upgrade from Ceph Jewel to Luminous (12.1.0 or higher) on Proxmox VE 4.x.

More information see Release Notes

In this HOWTO we assume that all nodes are on the very latest Proxmox VE 4.4 version and Ceph is on Version Jewel (10.2.7).

The Cluster must be healthy and working.

On a cluster member you have to set sortbitwise. This is very important, if this flag is not set you can lose all your data.

ceph osd set sortbitwise

To avoid re-balance during the upgrade process set noout.

ceph osd set noout

Since Luminous you have to allow explicit to delete a pool. Edit /etc/pve/ceph.conf with your preferred editor and add this line in section [global]

mon allow pool delete = true

Change the current Ceph repositories from Jewel to Luminous.

sed -i 's/jewel/luminous/' /etc/apt/sources.list.d/ceph.list

More information see Ceph Packages

Upgrade all your nodes with the following commands.

apt-get update && apt-get dist-upgrade

It will upgrade the Ceph on your node to Luminous. After the update you still run the old jewel binary.

After all cluster nodes are upgraded you have to restart the monitor on each nodes were a monitor run.

systemctl restart ceph-mon@<MON-ID>.service

Then restart all OSD's on all node

systemctl restart ceph-osd.target

After your node has successful restarts the daemons, unset the 'noout' flag. On the GUI or by this command.

ceph osd unset noout

Now check if you Ceph cluster is healthy.

ceph -s

You will get a warning like this "require_osd_release < luminous" you can fix it with the following command.

ceph osd require-osd-release luminous

Also it is recommended to set the tunable to optimal, but this will produce a massive rebalance.

ceph osd set-require-min-compat-client jewel

ceph osd crush tunables optimal