[pve-devel] [PATCH] migration : enable mtunnel for insecure migration

Thomas Lamprecht t.lamprecht at proxmox.com
Thu Aug 17 11:56:08 CEST 2017


the base idea is good, IMO, some comments in line,

On 08/10/2017 09:15 AM, Alexandre Derumier wrote:
> We only use it to send commands faster like resume
> 
> Signed-off-by: Alexandre Derumier <aderumier at odiso.com>
> ---
>   PVE/QemuMigrate.pm | 8 ++++++++
>   1 file changed, 8 insertions(+)
> 
> diff --git a/PVE/QemuMigrate.pm b/PVE/QemuMigrate.pm
> index fc847cc..8271adf 100644
> --- a/PVE/QemuMigrate.pm
> +++ b/PVE/QemuMigrate.pm
> @@ -635,6 +635,14 @@ sub phase2 {
>   	} else {
>   	    die "unsupported protocol in migration URI: $ruri\n";
>   	}
> +    } else {
> +	#fork tunnel for insecure migration, to send faster commands like resume
> +	$self->log('info', "start remote tunnel");

I'd rather move the log line from the if (secure) branch out so that we
have this line only once.

> +	my $pfamily = PVE::Tools::get_host_address_family($nodename);
> +	my $lport = PVE::Tools::next_migrate_port($pfamily);
> +	my $tunnel_addr = "$lport:localhost:$rport";
> +

I would omit those three lines above, its not needed for the insecure
case, the $tunnel_addr parameter from fork tunnel is optional.

> +	$self->{tunnel} = $self->fork_tunnel($tunnel_addr);

use:

  $self->{tunnel} = $self->fork_tunnel();

instead.

>       }
>   
>       my $start = time();
> 

I.e., a minified (slightly tested) version of your patch could be:

------8<------

diff --git a/PVE/QemuMigrate.pm b/PVE/QemuMigrate.pm
index fc847cc..7f39138 100644
--- a/PVE/QemuMigrate.pm
+++ b/PVE/QemuMigrate.pm
@@ -601,9 +601,9 @@ sub phase2 {

      die "unable to detect remote migration address\n" if !$raddr;

-    if ($migration_type eq 'secure') {
-       $self->log('info', "start remote tunnel");
+    $self->log('info', "start remote tunnel");

+    if ($migration_type eq 'secure') {
         if ($ruri =~ /^unix:/) {
             unlink $raddr;
             $self->{tunnel} = $self->fork_tunnel("$raddr:$raddr");
@@ -635,6 +635,9 @@ sub phase2 {
         } else {
             die "unsupported protocol in migration URI: $ruri\n";
         }
+    } else {
+       # use mtunnel to send commands without the ssh/perl startup delay
+       $self->{tunnel} = $self->fork_tunnel();
      }

      my $start = time();


------>8------




More information about the pve-devel mailing list